#Driver impreasora star tsp100iii how to#

Printing your Network Configuration and Current IP Parameters.This is your printer's new dynamic IP address.Ĭonnecting your printer to your computer by the AP network mode involves: Under Current IP Parameters Status, take note of the IP Address.Note: If a connection is not established after repeating steps 1-3, refer to Star Micronic's FAQ - Cannot connect to network article. Once the connection between your printer and router is established, the Ready light will be solid and your Network Configuration and Current IP Parameters Status will print automatically.Note: Steps 1 and 2 need to be done within 30 seconds of each other. On the back of your printer, press and hold the red PAIR button until the blue Ready light in front of the printer starts blinking.Note: If your router does not support WPS then you can connect by the AP network mode however this can be quite technical, and we would highly recommend getting a router that has WPS instead. If your router supports WPS, it will have a button with this logo. The simplest way to connect your printer to your wireless network is by WPS. Push the lid down to snap the latch shut.Ĭonnecting your printer to your wireless network.Pull the paper out past the cutter at the front of the printer.Inset the paper roll in the orientation below.To open the printer's lid, push the latch on the right away from you and lift the lid upwards.Turn on the printer and wait for the blue Ready light to become solid.Connect the power cord to your printer and an electrical outlet.If you have the wired TSP100 or TSP143 model, click here. Note: This article is specifically related to the Star TSP100iii wireless model.

#Driver impreasora star tsp100iii how to#

This article will show you how to install your Star Tsp100iii receipt printer on a Mac computer.